7.1.    PERSONNEL DOORS
7.1.1    Personnel doors shall be insulated standard 1-3/4" full flush 20 gauge swing doors, complete with a standard duty cylindrical lock. All doors shall also include flush hinges, door sweep, threshold and structural sub-jambs of Cee sections to insure rigid placement. (First girt usually acts as door header.) Flashing to close off panel edges included. Door sizes are standard 3070, 4070, 6070. Other sizes available upon request. Glazing not by The Company. All personnel doors are to be field located.

7.2.    TRANSLUCENT PANELS
7.2.1    Translucent panels shall have the same configuration as the specified covering. Translucent panels shall be of translucent polyester resin reinforced glass fiber. The polyester used shall be specially formulated to produce a weather resistant, sun resistant, stabilized product.

7.3.    OVERHEAD DOOR FRAMING
7.3.1    Overhead door framing shall be designed to resist applicable windloads and shall consist of C section jambs and header.
7.3.2    Galvalume flashing painted , all available trim colors (specify color) shall be provided to conceal and close off panel edges around openings when steel siding is utilized. The flashing shall be of a type to completely conceal the red iron door framing. Partial flashing available at reduced cost.
7.3.3    Special flashing available to close off framed openings, if required, when other than steel siding is utilized. Details and shipping list must be supplied.
7.3.4    Overhead doors not by The Company.

7.4.    WINDOW FRAMING
7.4.1    Window framing shall consist of Cee section for jambs, header and sill to insure rigidity. Flashing included to close off panel edges and conceal the red iron window framing. Special flashing available, if required, to seal off window framed opening when other than steel siding is utilized. Details and shipping list must be supplied. Glazing not by The Company

 

7.5.    VENTILATORS
7.5.1    Stationary roof ventilators are gravity type, manufactured from 24 gauge galvanized steel in which all welds, soldered seams, rivets and fasteners are clean, tight, and secure. Ventilators feature seamless spun caps which are leak proof. Straight through drainage eliminates clogging by airborne debris. Mounting jack matches roof slope. Vents utilize negative air pressure through a 14" throat as an operating principle. Overall width of vent is 22" and height 10-1/2", not including mounting jack dimension. Power ventilation can be added before or after installation by adding fan section.

7.5.2    Spinning turbine vents use pre-lubricated ball bearing action for easy operation of rotor head. Suction is maintained through 12" throat even at low wind velocities. 360o operating surface assures access to wind currents regardless of direction. The vents rotor shaft and bearing assembly are manufactured in galvanized steel and are encased in a corrosion resistant housing to assure long operational life. Mounting jacks matches roof slope.
7.5.3    Ridge ventilators come in 10' sections with 9" or 12" throat (specify which), damper and 15' chain loop, controlled by a worm gear operator to adjust damper (longer chain available as option).